IDM Indicator MT5 Setup: Volume Profile & DP Zones
Step-by-step implementation guide for the IDM Indicator on MT5. Learn how to configure Volume Analysis (POC, VAH, VAL), DP boxes, and filter setups for R:R.

To trade Smart Money Concepts (SMC) successfully on MetaTrader 5, you need accurate execution and the right tools set up.
This guide will walk you step by step through setting up the IDM Indicator's advanced features, focusing on Volume Analysis, Decision Points (DP), and how it works with risk management tools.
Step 1: Turn On Volume Profile Levels
You can turn on Volume Profile levels for each wave leg on your chart to add volume confluence to your structural analysis
POC (Point of Control)
Enable to display the most active price level of the leg.
VAH & VAL (Value Area High / Low)
Change to plot the upper and lower bounds of the 70% volume band.
Actionable Tip: If they clutter your chart, don’t leave these levels on all the time. Turn them on when price gets close to your POI to verify liquidity based on volume.
Step 2: Working with the Decision Point (DP) Box
Just outside your main POI is the DP box, a key companion tool.
If your primary POI doesn't hold price, your secondary reaction zone is the DP box (with a special dotted outline and its own internal 50% line).
Use the DP feature in your control panel to know where the range price is most likely to go if the initial structure breaks.
Step 3: R:R Filter w/ Synergy PA Line
Use the PA Line tool and Full POI Box features of the IDM indicator for a higher win rate.
When you reach a Decision Point or a Volume level, use the PA Line to know exactly what the Reward-to-Risk (R: R) ratio is before you get into the trade. If your minimum is lower than the R: R, dump the set-up.
This strict filtering protocol keeps you to setups that pass every rule.
Explore the IDM Indicator

